New lower bounds on the radius of spatial analyticity for the KdV equation

The radius of spatial analyticity for solutions of the KdV equation is studied. It is shown that the analyticity radius does not decay faster than $t^{?1/4}$ as time t goes to infinity. This improves the works of Selberg and da Silva (2017) [30] and Tesfahun (2017) [34]. Our strategy mainly relies on a higher order almost conservation law in Gevrey spaces, which is inspired by the I-method.     

The visible and ultraviolet organic light-emitting diodes with germanium dioxide as facile solution-processed anode buffer layer

Germanium dioxide (GeO₂) aqueous solutions are facilely prepared and the corresponding anode buffer layers (ABLs) with solution process are demonstrated. Atomic force microscopy, X-ray photoelectron spectroscopy and ultraviolet photoelectron spectroscopy measurements show that solution-processed GeO₂ behaves superior film morphology and enhanced work function. Using GeO₂ as ABL of organic light-emitting diodes (OLEDs), the visible device with tris(8-hydroxy-quinolinato)aluminium as emitter gives maximum luminous efficiency of 6.5 cd/A and power efficiency of 3.5 lm/W, the ultraviolet device with 3-(4-biphenyl)-4-phenyl-5-tert-butylphenyl-1,2,4-triazole as emitter exhibits short-wavelength emission with peak of 376 nm, full-width at half-maximum of 42 nm, maximum radiance of 3.36 mW/cm² and external quantum efficiency of 1.5%. The performances are almost comparable to the counterparts with poly (3,4-ethylenedioxythiophene):poly (styrenesulfonate) as ABL. The current, impedance, phase and capacitance as a function of voltage characteristics elucidate that the GeO₂ ABL formed from appropriate concentration of GeO₂ aqueous solution favors hole injection enhancement and accordingly promoting device performance.     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

气体压强对纳秒激光诱导空气等离子体特性的影响

环境气体的压强对激光诱导等离子体特性有重要影响.基于发射光谱法开展了气体压强对纳秒激光诱导空气等离子体特性影响的研究,探讨了气体压强对空气等离子体发射光谱强度、电子温度和电子密度的影响.实验结果表明,在10-100 kPa空气压强条件下,空气等离子体发射光谱中的线状光谱和连续光谱依赖于气体压强变化,且原子谱线和离子谱线强度随气体压强的变化有明显差别.随着空气压强增大,激光击穿作用区域的空气密度增加,造成激光诱导击穿空气几率升高,从而等离子体辐射光谱强度增大.空气等离子体膨胀区域空气的约束作用,增加了等离子体内粒子间的碰撞几率以及能量交换几率,并且使离子-电子-原子的三体复合几率增加,因此造成原子谱线OⅠ777.2 nm与NⅠ821.6 nm谱线强度随着气体压强增大而增大,在80 kPa时谱线强度最高,随后谱线强度缓慢降低.而离子谱线N Ⅱ 500.5 nm谱线强度在40 kPa时达到最大值,气体压强大于40 kPa后,谱线强度随压强增加而逐渐降低.空气等离子体电子密度均随压强升高而增大,在80 kPa后增长速度变缓.等离子体电子温度在30 kPa时达到最大值,气体压强大于30 kPa后,等离子体电子温度逐渐降低.研究结果可为不同海拔高度的激光诱导空气等离子体特性的研究提供重要实验基础,为今后激光大气传输、大气组成分析提供重要的技术支持.     

Preparation,structure elucidation,and antioxidant activity of new bis(thiosemicarbazone) derivatives

Schiff-base–bearing new bis(thiosemicarbazone) derivatives were prepared from terephthalaldehyde and various thiosemicarbazides. FT–IR, ¹H NMR, ¹³C NMR, and UV–Vis spectroscopic methods and elemental analysis were used to elucidate the identification of the synthesized molecules. The in vitro antioxidant activity of the synthesized compounds was analysed with the 1,1-diphenyl-2-picryl hydrazyl free-radical–trapping process. The synthesized compounds exhibited lower antioxidant activity than the standard ascorbic acid. IC₅₀ values of the synthesized molecules measured from 3.81 ± 0.01 to 29.05 ± 0.11 μM. Among the synthesized compounds, compound 3 had the best antioxidant activity. Moreover, this study explained the structure–activity relationship of the synthesized molecules with different substituents in radical trapping reactions.     

Distinguishability and Disturbance in the Quantum Key Distribution Protocol Using the Mean Multi-Kings’ Problem

We introduce a quantum key distribution protocol using mean multi-kings’ problem. Using this protocol, a sender can share a bit sequence as a secret key with receivers. We consider a relation between information gain by an eavesdropper and disturbance contained in legitimate users’ information. In BB84 protocol, such relation is known as the so-called information disturbance theorem. We focus on a setting that the sender and two receivers try to share bit sequences and the eavesdropper tries to extract information by interacting legitimate users’ systems and an ancilla system. We derive trade-off inequalities between distinguishability of quantum states corresponding to the bit sequence for the eavesdropper and error probability of the bit sequence shared with the legitimate users. Our inequalities show that eavesdropper’s extracting information regarding the secret keys inevitably induces disturbing the states and increasing the error probability.     

Edge-enriched graphene with boron and nitrogen co-doping for enhanced oxygen reduction reaction

Carbon-based electrocatalysts for oxygen reduction reaction (ORR), especially in anion exchange membrane fuel cells (AEMFCs), have received a lot of attention because they exhibit excellent stability and are comparable to commercial Pt/C catalysts. Currently, to maximize the catalytic activity of carbon-based electrocatalysts, there are two major strategies: heteroatom doping or exposing active edge sites. However, the approach of increasing heteroatomic dopants of active edge sites has been rarely addressed. In this study, we present a simple strategy to prepare edge-enriched graphene catalysts with an increased ratio of heteroatomic dopants suitable for ORR of AEMFCs. The catalysts were prepared under harsh oxidation conditions, followed by a simple co-doping process with boron and nitrogen. The ORR activity of the catalysts was observed to be related to an increase of edge sites with heteroatomic dopants. We believe that the edge-enriched structure leads to accelerated electron transfer with enhanced oxygen adsorption.     

Microstructure evolution of room-temperature-sputtered ITO films suitable for silicon heterojunction solar cells

Thickness influence on structural, optical and electrical properties of sputtered indium tin oxide (ITO) with thickness ranging from 60 up to 430 nm films has been studied. At the increase of the film thickness crystallinity degree and grain size increased, whereas tensile structural distortion as well as resistivity decreased. It was observed that a microstructure evolution takes place: the initial amorphous layer evolved in polycrystalline phase, with a grain–subgrain surface morphology. Carrier concentration increased at the increase of the film thickness and a general relationship between electrical characteristics and structural distortion has been found. In thinner films larger tensile distortion allowed to include larger amount of interstitial O and/or Sn atoms in the lattice. An appreciable impact of the thickness was also observed on electro-optical properties in terms of changes in energy gap, resistivity and optical absorption. Silicon heterojunction solar cells have been produced and J_sc as high as 33.0 mA/cm² has been obtained.     

小直径棒材超声横波检测仿真分析

采用超声水浸聚焦斜入射方式进行小棒材表面、近表缺陷检测时,声波在水/棒和棒/缺陷界面会发生反射、折射、散射、衍射及波形转换等一系列物理变换。此时缺陷可检性对声波入射条件十分敏感,常出现由于检测条件设置不当而导致缺陷漏检、误检的情况。为解决这一问题,本文针对小棒材超声斜入射检测中的主要参数——入射角和水距,开展声场及缺陷声响应仿真,研究检测参数对不同部位缺陷检测能力的影响,并对仿真结果进行试验验证。通过研究得到了检测水距、入射角度对缺陷检测能力的影响,并得到最优检测条件。试验验证结果表明研究制定的检测方案可有效检测出表面、近表面裂纹缺陷。